MRV FPV250 ‘Next Level’

MRV FPV250 Next Level

*Preflashed – We flash the latest firmware on your ESCs and Flight Controller so all you have to do is fly.


Naze32 or CC3D Flight Controller (Cleanflight/Betaflight)

2205-2300kv Motors

20A ESCs (BLHeli Flashed)

DAL 5040/5045 nylon or carbon fibre propellers

FPV Gear:

7″ FPV LCD TV Screen

700TVL Super HAD CMOS FPV Camera

2.1mm wide angle lens

*25mw Video Transmitter

32 Channel Video Receiver

Upgraded Cloverleaf antennas


Mobius/GoPro camera mounting plate w/anti vibration mounts

XT60 Lipo connector

Super tough nylon Lipo strap

Low voltage alarm

You will need:

Flight Battery – 3S or 4S (XT60 Connector)

Video Receiver Battery 2S (JST Connector)

FPV Screen Battery 3S (XT60 Connector)

6CH Radio Transmitter & FPV Goggles for full immersion flying

We can include lipo batteries and 6 channel radio into a complete package for you just send us an email to get a quote.

*IMPORTANT: Laws applicable to the operation and use of remote control aircraft and FPV video signal transmitters vary around the world. Many countries limit the use of aircraft to line of sight (LOS) only. Many countries limit video power transmitters to 25mw and in some countries it is legal to import and own them but not to operate them. Please check your countries relevant laws before buying. The included transmitters are compliant with Australian standards and law.





MRV FPV250 Next Level FPV Ready Package

MRV FPV250 Next Level


Emax/SunnySky or DYS motors




Multi layer carbon fiber


FPV TV Video Screen

Disclaimer: In Australia the law prohibits analogue video signal transmitters higher than 25mw. Caution must be exercised when using any 5.8Ghz video system. Always turn on your receiver and test to be sure no one else is using the band. Never turn on your system while another remote control aircraft is airborne. Please review the legislation page for more information.




There are no reviews yet.

Be the first to review “MRV FPV250 ‘Next Level’”

Your email address will not be published. Required fields are marked *